6
STEP1 Turn on the equipment that you want the
remote control to operate (Cable Box, TV,
or DVD).
STEP2 Press the [DEVICE] button and the
[OK/SEL] button simultaneously for three
seconds. The device LED will turn on
indicating that it is ready to be
programmed. The LED will remain on for
20 seconds. The next step must be
entered while the LED is on.
STEP3
Press the [CH5] or [CH6] button one at a
time or keep it pressed. The remote will
emit a series of Power ON/OFF code
signals. Release the [CH5] or [CH6]
button as soon as the equipment turns off.
*Note : You can verify that you selected the
correct code by pressing the [MUTE]
button. The equipment should turn On or
Off.
STEP4 Press the same [DEVICE] button to store
the code. The Device LED will blink twice
to confirm that the code has been stored.
E.
E.
To find the Three-Digit Code that Was
To find the Three-Digit Code that Was
Programmed using the Auto Search Method
Programmed using the Auto Search Method
STEP1 Press the appropriate [DEVICE] button
and the [OK/SEL] button simultaneously
for three seconds. The device LED will
turn on for 20 seconds. The next step
must be performed while the LED is on.
STEP2 Press the [INFO] button. The device LED
will blink a number of times indicating the
number of each digit for the code. Each
digit is separated by a one second
To Next Page
Loading...
Need help?
General
