43
Turn the fan on and change the speed until the most
noticeable swing occurs (usually the highest speed).
Turn off the fan. Select a blade and place the balancing clip
on the edge of it, between the holder and the tip.
Turn the fan back on and see if the tilt has improved or
worsened. Turn the fan off and change the clip to another
blade to check again. Repeat this process for all blades and
note which blade has the most noticeable improvement.
Put the clip back on the blade where you noticed the greatest
improvement. Move the clip along the blade and turn on the
fan to find the position where the clip offers the better
improvement.
Next, remove the clip and place one of the balance weights
on the point where the clip was placed. To do so separate the
white sticker with your fingernails or, if necessary, carefully
use a knife or scissors.
INFORMATION ABOUT LIGHT BULBS
Light bulbs are not included with this product.
This fan can support two E27 light bulbs with a maximum power of
60W (incandescent type). If you are going to use a LED light bulb,
check the power equivalence before you install it.
Note: The fan has reversible blades.
4. USING THE APPLIANCE
This device is very easy to use and does not require much
knowledge. However, we advise you to familiarize yourself with the
instructions below.
The fan has 3 power levels that can be selected through the remote
control. It also has a timer of up to 8 hours and a Winter function, as
detailed below.
To Next Page
Loading...
