17
beFore usiNg the aPPliaNce the First time
1. Remove all packaging materials and any
transport safety devices.
2. Clean all components with a damp cloth,
as described in the chapter “Cleaning and
care” on page 18.
assembly
Fig. 1
Fig. 2
1. Before assembling the appliance, make
sure that it is not plugged into the electrical
outlet.
2. Place the appliance on a solid, level and dry
surface.
3. Push the screw cover onto the feed screw
axle. Make sure that the notches on the
cover line up with the depressions on the
feed screw axle. (Fig. 1)
4. Push the feed screw axle through the front
cover so that the feed screw is within the
front cover (Fig. 2).
5. Fasten the kneader to the axle. The feed
screw axle is provided with a notch, which
must align with the corresponding guide rail
in the kneader. (Fig. 3).
Fig. 3
1 2 3 4 5 6 7
1 Shortbread biscuit
2 Pappardelle
3 Linguine
4 Fettuccine
5 Spaghetti
6 Tagliatelle
7 Rigatoni
Pos. EXT: extrude pasta
Pos. OFF: switch off appliance
Pos. MIX: mix ingredients
Before assembling the appliance, make sure that it is not
plugged into the electrical outlet and that both switches
are set to OFF.
To Next Page