XFT195 LineMiss™ Quick User Guide
CONTROL PANEL
RECALLING AND STARTING A SAVED PROGRAM
For Programs P1 – P6 select
the desired Program.
Press START/STOP to launch
the program.
For Programs P7 – P99 press
and then
to reach the program.
Press START/STOP.
MANUAL USE
❶ PREHEATING:
Press STEP and then + or -
To set the desired temperature.
❷ SELECT STEP 1:
Press the STEP button.
❸ SET COOKING TIME:
Check the time LED is on.
Press + or – to set time or
press – to reach INF mode.
❹ SET COOKING TEMPERATURE:
Press SELECT to light the temp. LED
Press + or – to set temperature.
❺ SET HUMIDITY:
Press SELECT to light the humidity LED.
Press + or – to set humidity:
OFF for no steam or 20%, 40%, 60%,
80% or 100% steam.
❻ SET AIRFLOW SPEED:
Press SELECT until SP1 or SP2 show.
Press + or – to select speed:
SP1 = 1000 rpm no inversion
SP2 = 2700 rpm with inversion
❼ ADDING EXTRA STEPS:
If needed, add another cooking step.
Press STEP and repeat the above
process.
❽ START COOKING:
Press START/STOP.
Once cooking has finished, you can
press + if you want to repeat the
same process.
1. STEP Button
2. STEP LED
3. Display
4. Cooking Time LED
5. Cooking Temperature LED
6. Humidity LED
7. SELECT Button
8. + and – Buttons
9. START/STOP Cooking
10. P1 – P6 easy access saved programs
11. Access to saved programs
12. Saves set program
13. Switches from oven to prover
Unox UK Ltd. Unit 1, Camberley Business Centre, Stanhope Road, Camberley, Surrey, GU15 3DP / Tel. 01252 851492 / info@unoxuk.com
Need help?
General
