16
USING THE ALTA – Booster Assembly
IMPORTANT: This product is NOT to be used without a backrest,
and the backrest should never be separated from the base.
1 Lay the Booster Seat Bottom on
floor facing up.
2 Attach the Backrest to the
Booster Seat Bottom, by hooking
over the seat bar hinge on the
seat bottom as shown.
3 Rotate the Backrest up until
it clicks into the full upright
position and locks into place.
4 Tuck the Fabric Panel between the
Backrest Fabric Cover and the Seat
Back Frame. Be sure Fabric Panel is
flat against the Seat Back Frame.
2
1
To Next Page
Loading...
