22
USING THE ALTA – Install Using Lower Anchors
NOTE: Before installing the booster, pull the Rigid Lower
Anchor Connectors to ensure they are fully extended from
the housing.
3 Place the booster on the vehicle seat. Push the Rigid
Lower Anchor Connectors onto BOTH Lower Anchors until
you hear a click. The red to green indicators located on
connectors should be green indicating a secure connection.
Pull back on each connector to ensure secure.
4 Pull Lower Anchor Release Handle and push the booster
in the seat bight until the backrest sits against the vehicle seat
back.
The back of the booster MUST fit tightly
against the back of the vehicle seat, and the
front of the booster MUST NOT hang over
the front of the vehicle seat. If the vehicle
head restraint cannot be adjusted or removed,
a different seating position or different
booster seat should be used.
The Rigid Lower Anchor Connector
indicators will both show GREEN when
properly secured.
4
3
To Next Page
Loading...
