43
Recline angle is correct. Check the level angle indicator on base to ensure the
bubble is still within the lines. NO partial bubble allowed.
ALWAYS check the Recline Position Indicator on the base and adjust the recline bubble
to be between the designated range indicated for the infant insert use.
Make sure the load leg is secured and contacts the vehicle floor.
Check that the load leg angle indicator is GREEN. Any RED showing
indicates that the load leg is not properly level with the vehicle floor.
Always store the load leg under base when not in use.
ALL STEPS MUST BE COMPLETE.
If not, return to page 34 and start over.
BASE INSTALLATION WITH VEHICLE SEAT BELT
Safety Check
To Next Page
Loading...
