35
5 No Pay Period—Select 05 for job tracking mode,
which will disable all pay period calculation and
daily calculation settings and will allow you to
punch in all six columns of the time card.
Use the + and – buttons to make your selection, then
press Enter to conrm the setting.
NOTE: One time card will be used per pay period.
The row on which your punch appears will depend on
your pay period settings. For more information, see
“7.0—Using the HN4000.”
Setting the Minute System (code 02)
When the code “02” appears, set the minute system
you would like to use. The options are:
00 One hour divided into 60 minutes
01 Hundredths of an hour
Use the + and – buttons to make your selection, then
press Enter to conrm the setting.
Setting Punch Rounding (code 03)
When the code “03” appears, set the conguration
of punch rounding you would like. It will be set in
increments and used for daily time calculations. The
options are:
00 No Punch Rounding
01 5 Minute 3 Breakpoint
02 6 Minute 3 Breakpoint
03 10 Minute 5 Breakpoint
04 15 Minute 8 Breakpoint
05 60 Minute 30 Breakpoint
To Next Page
Loading...
