URBANGLIDE RIDE-100 User Manual

7
Instructions of Buttons
1- Switch: long press the power button to turn on/off the power;
2- Acceleration: press the right acceleration button to start and accelerate;
3- Brake: hold the brake handle to brake.Lightly step on the rear fender to assist the brakes
4- Short press the function key to directly adjust the speed
 Beginner mode: no characters in the gear position
 Normal mode: gear characters display white
 Sports mode: gear characters display red
5- Headlights: Press the function button twice shortly to turn on the headlights, and the taillights are
always on; In the light-on state, press the function button twice shortly to turn off the headlights and
taillights
6- Cruise mode: keep the current speed for 6 seconds to enter the cruise mode
7- Exit the cruise mode when pressing accelerator again or brake
Pre-assembly instructions
1. Pull up the lever while pressing
down the rear wheel fender.
2. Raise the pole, fasten the folding
spanner, and use the folder fixing
ring to fix the folder wrench.
3. Fix the brake lever with M5 hex
wrench.
4. Tighten handlebars (pay
attention to the direction of
rotation when tighten.

URBANGLIDE RIDE-100 Specifications

General

Motor Power	250W
Max Speed	25 km/h
Max Load	100 kg
Wheel Size	8.5 inches
Category	Electric Scooter
Tire Size	8.5 inches
Charging Time	4-5 hours
Foldable	Yes
Range	30 km
Brake Type	Disc Brake
Weight	14 kg