2.Functions
3.Display functions
1. Turn on and off: Long press to turn on or off.
2. Power-Off Automatically: After the display stops working
acceleration/ deceleration and buttons for more than 10
minutes, the scooter automatically turns off.
3. Speed switching: high(S) / (D) medium / (ECO) low
Press the button two times to switch speed gears.
4. Lighting: Short press the button to control the lighting
5. Constant speed cruise setting: After keeping the
Acceleration handle steady for 6s, when hear ’beep’ sound,)
to indicate that it enters the constant speed cruise mode.
You can exit the constant speed cruise by braking or
readjusting the speed.
6. Braking: Press the brake handle bar to stop the scooter,
the rear light will flash.
7. Battery power: Battery voltage above 40V, there are five bars; Battery voltage
38.5V, there are four bars; Battery voltage 37.5V, there are three bars; Battery
voltage 36.5V, there are two bars; Battery voltage 35V, there is one bar.
8. Accelerator starting method: Kick-start. The motor does not rotate after pressing
the throttle. After sliding the motor, the throttle is driven.
To Next Page
Loading...