5.Fault codes
E1 => Keep the throttle pressed to prevent it from spinning
E2 => Brake handle is pressed when turning on the scooter
E3 => Accelerator line is not connected
E4 => Brake line is not connected
E5 => MOS failure or Motor is short circuit.
E6 => Motor hall failure
E7 => Communication failure
6.Assembling the device
Step 1. Fix the steering rod and
Step 2. Set handle bars vertical; open the parking bridge
Step 3. Using Hex wrench to tighten the bar
Step 4. Testing the power finish packing switch
power after the handle assembling with screws
To Next Page
Loading...