Urive Zest ... 18 ... User's Guide
08. Functions
Classification
Situation Action Voice information
Power
(ACC ON)
Power cable is connected to
the body.
BLUE LED is turned on and then off after booting up, GREEN LED
is turned on.
After booting up, consecutive video files are saved in 35 MB files.
“Start recording.”
Switch is pressed and held. Power On/Off Power OFF: “Jingling”
Drive mode
Parking mode → ACC (Engine) ON
Mode switching with LCD ON -> Constant recording starts. “Shifting to the driving mode.”
If an impact file has been
produced while parking
-
“Impact has been detected
while parking.”
When entering the Video list
or Preference menu
When exiting the menu, “Start recording.” Recording is restarted
with the voice information
“Stop recording”
Receiving GPS signal - “GPS is connected”
Parking
mode
Parking mode → ACC(Engine)
OFF
Mode switching with the LCD off, starting to sense motion and
impact, Saves a video from 10 seconds before to 20 seconds
after (30-second duration)
- Monitoring: BLUE LED blinking every 1 seconds
Motion sensing: Blinking 4 times per second
- Saving due to a motion: Blinks 6 times per second.
“Shifting to parking mode.”
Others
Update
BLUE LED blinks during update,
and, then, it reboots after the BLUE LED is turned off.
“Starting the update.”
When entering high-
temperature cutoff state
-
“Video is continuously recorded,
and the LCD will be recovered
after a certain time.”
When there is no SD card, or there
is a problem with the SD card
Rebooting after a voice information “Please check the SD card.”
To Next Page
Loading...
