Caution.
Not following the instructions can lead to minor Injuries or damage to the products.
!
If the Product is directly connected to the car, do not use
the product for an extensive period of time.
It may discharge the battery.
Install the Product in unaffected area by the Navigation or
HIPASS device.
Reflections of images of Navigation or HIPASS may cause
poor recording quality.
Make sure that the double-side adhesive tape is firmly
affixed during installation.
The Product may show poor performance by over time
moving or motor vibration.
Keep the windshield clean.
Foreign materials may prevent normal recording of images.
Watch out for using memory cards and removing it.
Uncertified Micro SD card may not be recorded properly.
Please remove the power cable before inserting or
removing the SD Card
Back up files periodically.
When the SD Card is full, the oldest file in the Card will be
overwritten by a new file. Please back up data periodically
to prevent unwanted data loss.
Please do not use sharp devices on the LCD.
The touch panel or LCD may be damaged by sharp devices
when the black box is set up with them on the LCD.
Avoid an area where the product is exposed to direct
sunlight when parked.
If used for long hours in an air-tight environment inside a
car and in direct sunlight, the product may malfunction.
To Next Page
Loading...
