This User Guide has been developed for the WatchDog Paging Alert Receivers.
The USAlert WatchDog pager has been developed specifically for the public safety
environment for alerting firemen and other emergency personnel. In addition to public
safety systems, the WatchDog pager can be used in any radio system that requires tone
alerting and channel monitoring. The all new WatchDog pager offers many new and
exciting features over any previous generation of voice pager.
WATCHDOG DISPLAY ICONS
O This ICON will be displayed in the lower left side of the display when power is
turned on to the pager.
CH 12345 The channel in current operation will be displayed as CH and the
corresponding channel number in the left center of the display.
This ICON will be displayed when the pager has tone alert enabled.
((o)) This is the ICON displayed when the pager has vibrate alert enabled.
The battery ICON is located in the lower right corner of the display. There are
three bars indicating the level of charge remaining. Three bars indicate a fully charged
set of batteries.
CHANGING BATTERIES
Locate the metal tab under the top of the belt clip. Lift the tab slightly towards the belt
clip and slide the belt clip up from the bottom of the pager and remove the belt clip.
Remove the captive screw located under the belt clip location. Lift off the battery door
and remove and replace the batteries. Note that the batteries all face in the same
direction. Observe proper polarity when reinserting the batteries.
Turn the pager on to make sure the batteries are inserted properly and then turn the pager
back off. Replace the battery door and tighten the captive screw. Caution to not over
tighten the screw.
Reinstall the belt clip by depressing the tab and the metal latch inwards towards the top of
the belt clip.
Note that there are two slide rail features on both sides the metal latch on the belt clip.
These features mate with groves in the back cover for the belt clip. Slide the belt clip
back into place. You will feel and hear a click sound when the belt clip has been fully
positioned into its proper location.
To Next Page
Loading...