WATCHDOG DISPLAY TEXT AND ALERT STATUS INFORMATION
The WatchDog pager provides start up screen text that can be customized in the
WatchDog programmer. There is also a provision to add standby text if desired. Both
features are available in the WatchDog programmer.
Additionally, the WatchDog pager will display TEXT assigned to an address, date and
time that an alert was received, and the sequence number of the alert.
The WatchDog allow programming special text in the code plug programmer of up to 14
characters to be displayed when that address has been alerted. The display will
alternately show the pre-programmed text, then the alert number with date and time
stamp.
WATCHDOG PAGER CONTROLS AND FUNCTIONS
On / Off and Volume Control
The on / off volume control is located on the top of the pager and allows turning the
pager on or off and provides a continuous adjustment for the audio and alert levels
providing the alert is not set for the maximum volume option.
Three Position Function Switch
The three position function switch is located on the top of the pager in the center. Each
position can be individually programmed for the channel desired and type of alerting.
Scan is only selectable in switch position two.
Reset Switch
The reset switch is located on the top of the pager and is typically used to reset the audio
and put the pager back into the standby mode. It can also be used to place the pager into
the “quick monitor” or “audio lock on” mode of operation. Depress the reset button and
release in less than .75 seconds and the pager will return to the standby mode. Press and
hold for .75 but less than 1.5 seconds and the pager will enter monitor mode. Press for
more than 1.5 seconds and the audio will lock on and remain on continuously until reset.
Front Control Buttons
There are three buttons located on the front of the pager. The far left button provides
entry into the pagers menu and controls advancing thru the menu in a forward direction.
The center button also provides entry into the pagers menu and controls advancing thru
the menu in a reverse direction. The right button provides the playback function for
models with voice memory and the select function if any item needs to be changed as
selected in the pagers menu.
To Next Page
Loading...