Pager Display Menu Items
Set time and date - To set the time and date depress either the left or center button and
then the right select button. Use the left or center buttons to change the date and then use
the right button to advance to the next date field. When the last data field is highlighted
and flashing and changed to the correct data then use the right button once again to
confirm the change.
Set frequency - In the WatchDog five channel models, there is a menu provision to select
the frequency of operation for F2. F2 can be any of four frequencies.
Once the frequency is selected for F2 operation, use the right button to confirm. The
pager will now operate on the new frequency when the three position switch is placed in
any position pre-programmed for F2 operation.
Push-to-Listen - If this option is enabled in the WatchDog programmer, the option will
also appear in the pagers menu. The selections are “PTL YES” and “PTL NO”. If “PTL
YES” is selected, then the option is enabled in the pager and any address selected for on /
off duty will be disabled. You can turn off PTL by selecting “PTL NO”.
Voice Memory Playback
WatchDog models with voice memory can dynamically record up to 4 minutes of
messages. Messages can be played back using the right button to initiate play back and
then using the left and center buttons to select which message to replay. If no messages
are stored, the display will show “NO VOICE MESSAGE”.
Depressing the right front button will start message playback. Each time the right button
is depressed, the last message stored will replay or repeat from the beginning. Using the
left or center button can change the message to be played once playback has been
initiated.
Delete message – To delete a message, first select the correct message to delete. Delete
can only occur while a message is being played back unless “Delete All” is selected.
When the correct message has been selected, depress and hold the right front button.
Delete message will appear on the display. Depress the right button once again to delete
the selected message or use the reset button to escape from the delete mode.
Delete all messages – To delete all messages, depress and hold the right front button.
Once the “delete message” appears, depress the center button to select “delete all
messages”. The display will then show “YES”. Depress the right button to confirm and
delete all messages.
Protect message – To protect a message from accidental removal, you can depress the
right button until “delete message” appears on the display. Then use the center or left
button to advance thru message control features. When “protect message” appears, use
the right button to select.
To Next Page
Loading...