36
TFT Circuit Voltage Low or Shorted
The Transmission Fluid Temperature sensor voltage is too low. A possible cause
of this could be that it is shorted to ground.
TFT Circuit Voltage High or Open
The Transmission Fluid Temperature sensor voltage is too high. The TFT sensor
circuit could be open.
Transmission is Overheating
The temperature in the transmission is above the allowed threshold (which can
be adjusted in the tuning software).
OSS Circuit Open or Sensor Missing
The Output Shaft Speed Sensor circuit is open or the sensor is missing.
ISS Circuit Open or Sensor Missing
The Input Shaft (Turbine) Speed Sensor circuit is open or the sensor is missing.
(if equipped)
OSS Sensor Signal Plausibility Error
The controller detected an unexpected value from this sensor and marked it as
faulty.
ISS Sensor Signal Plausibility Error
The controller detected an unexpected value from this sensor and marked it as
faulty. (if equipped)
Checksum error in table (Can be table 1-4)
A Checksum error has been found in the table corresponding to the number
shown. It will also disable saving Setup Menu changes for the bad table and
disable the tuning menu for the bad table. Connect the controller to a PC and
load a calibration using Shiftware.
Torque Converter Clutch Slip Error
Torque converter clutch slip detected when fully engaged.
Transmission Slip in Gear(s) 1, 2, 3, etc.
Transmission appears to be slipping in the indicated gear or gears.
To Next Page
Loading...