Need help?Do you have a question about the US Shift Quick 6 GEN2 and is the answer not in the manual?
Details manufacturer's warranty terms and limitations.
Caution regarding potential chemical exposure and health risks.
Steps for connecting the Quick 6 to EFI systems (Ground, Power, TPS).
Steps for connecting the Quick 6 to diesel systems (Ground, Power, TPS).
Wiring schematics for EFI, Diesel, and vehicle pinout.
Procedure for connecting the Quick 6 harness to the transmission.
Connecting the tachometer signal for system learning.
Verifying calibration and calibrating the throttle position sensor.
Resolving common errors encountered during TPS calibration.
Mounting location, electrical connection methods, and 6R80 specific notes.
Essential steps before starting the vehicle after installation.
Identifying TPS terminals and general setup guidelines.
Wiring diagram for 6R80 transmission solenoids, PRNDL, and TSS.
Detailed mapping of controller pins to internal transmission components.
Configuring TransBrake and using multiple calibration tables.
Setting up speedometer output and overdrive on/off functions.
Connecting cruise buttons, push buttons, and shifters for manual control.
Using the built-in display menus, home screen, and its different modes.
Detailed descriptions of Setup, Tune, and Diagnostics menus.
Introduction to Shiftware, loading calibrations, and system settings.
Editing shift points, line pressure, and managing adaptive learning.
Saving calibrations, writing to controller, and preventing errors.
General warnings, error display, and troubleshooting battery/solenoid issues.
Diagnosing undercurrent, shorted, and open circuit errors for solenoids and sensors.
Resolving table checksum, slip, ratio, PRNDL, and clutch data errors.
Phone number and email for technical assistance and product inquiries.
General| Brand | US Shift |
|---|---|
| Model | Quick 6 GEN2 |
| Category | Microphone system |
| Language | English |
To Next Page
