ACCESSORY CLEANING – AFTER EACH USE
Always wash accessory brushes with warm, mild soapy water after each use. Get in the good
habit of cleaning brushes before the dirt dries on them. All accessories can also be cleaned in the
dishwasher, except for the flexible hose. Accessories can be sanitized by steaming them with the
steam hose and the 1-hole nozzle.
DESCLAILING
Ø Every 6 months or
Ø When the steamer takes longer than 10 minutes to heat.
① Turn steamer over and unscrew (by hand) the drain plug.
② Drain all water in the steamer and replace the drain plug.
③ Pour 2 cups of vinegar and 4 cups of water into the holding tank.
④ Push Power and Steam Release buttons to run mixture into the boiler.
Ø After 1 minute, turn off Power button and let unit set for 30 minutes.
ØRemove drain plug and completely empty boiler tank. Replace drain plug when finished
draining.
ØNote: O-Ring is required to make a water tight seal.
Rinse the Boiler Tank
① Refill steamer with tap water.
② Turn ON by pushing the Power and Steam Release Buttons allowing water to move from the
reservoir tank to the boiler.
Ø Run for 1 minute.
③ Remove drain plug and drain until empty.
④ Steamer is ready for use when there is no sediments coming from the water draining from the
boiler.
Ø This step may need to be repeated.
NEVER ADD CHEMICALS INTO THE TANK! Adding any form of chemicals or
fragrance to the tank will void the warranty and could result in malfunction or damage to the
system.
Accessory Cleaning and Descaling
5
Do NOT empty boiler when steamer is hot.
To Next Page
Loading...
