2-76 Using the Operation Panel
1 After entering the administrator ID and password, press or
repeatedly until >>Sleep Level appears.
2 Press [OK]. A blinking question mark (?) appears.
3 Press or to select Quick Recovery or Energy Saver.
4 Press [OK].
5 Press [MENU]. The display returns to Ready.
Network (Setting for entering energy-saving mode when
connected to a network)
This sets whether or not the machine enters Energy Saver mode when
connected to a network.
1 After entering the administrator ID and password, press or
repeatedly until >>Network appears.
2 Press [OK]. A blinking question mark (?) appears.
3 Select On or Off using or .
4 Press [OK].
5 Press [MENU]. The display returns to Ready.
To Next Page
Loading...
