Utax P-C3060DN - Page 78

Using the Operation Panel 2-53
SNMPv3 (SNMPv3 setting)
Set SNMPv3.
1 Press  while >Protocol Detail > is displayed.
2 Press  or  repeatedly until >>SNMPv3 appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using  or .
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
FTP (Server) (FTP (Server) setting)
Select whether or not to receive documents using FTP.
1 Press  while >Protocol Detail > is displayed.
2 Press  or  repeatedly until >>FTP(Server) appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using  or .
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
SNMP (SNMP setting)
Select whether or not to communicate using SNMP.
1 Press  while >Protocol Detail > is displayed.
2 Press  or  repeatedly until >>SNMP appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using  or .
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
SMTP (SMTP setting)
Select whether or not to send email using SMTP.
1 Press  while >Protocol Detail > is displayed.
2 Press  or  repeatedly until >>SMTP appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using  or .
>>SNMPv3
? Off
>>FTP(Server)
? On
>>SNMP
? On
>>SMTP
? Off