Utilitech BNS-15U - Assembly Instructions; Care and Maintenance; Warranty

5
ASSEMBLY INSTRUCTIONS
CARE AND MAINTENANCE
WARRANTY
Before initial use some assembly is required.
With a phillips screwdriver, attach handle
to heater body using screws provided as
shown.
CLEANING:
CAUTION – Before cleaning the heater be sure to disconnect power cord and allow the heater to cool completely.
Clean the outside surface with a clean damp cloth. Do not use harsh chemical or abrasive cleaners. DO NOT
IMMERSETHEHEATERINWATER.Allowheatertodrycompletelybeforeuse.
Any other service should be performed by an authorized service representative.
REPAIR:
DONOTOPERATETHEHEATERWITHOUTTHEGRILLEINPLACE.DONOTUSETHEHEATERIFITHAS
MALFUNCTIONEDORBECOMEDAMAGEDINANYWAY.
STORAGE:
Keep original carton for storage of the heater. Coil and tie the power cord to avoid damage during storage.
LIMITED WARRANTY
ONEYEARLIMITEDWARRANTY
.Themanufacturerwarrantsthisproducttobefreefrommanufacturingdefects
in material and workmanship. This one-year warranty does not cover transit damages.
Thiswarrantydoesnotapplytothefinishonanyportionoftheproduct.Servingperformedbyunauthorized
persons shall render the warranty invalid. For warranty service, contact Customer Service at 866-994-4148,
8 a.m.- 8 p.m., EST, Monday – Sunday. Some states do not allow the limitation or exclusion of certain damages.
Therefore,theselimitationsandexclusionsmaynotapplytoyou.Thiswarrantygivestheconsumerspeciclegal
rights. You may have other rights that vary from state to state.
Printed in China
TURNING OFF:TurntheON/OFFPOWERLEVEL/FANDIALtotheOFFpositionbeforeunpluggingorplugginginthe
heater. Heater should be unplugged when not in use. To disconnect heater, turn controls to OFF, then remove plug
from outlet.
ADJUSTABLE THERMOSTAT: After heater has been turned on and the room has reached the desired temperature,
slowly rotate the thermostat control dial counter-clockwise until the heater shuts off (you should hear a faint “click”).
By leaving the thermostat at this setting it will automatically maintain this temperature. To lower temperature, rotate
the knob further counter-clockwise (towards the LOW < > position). To raise the temperature, rotate the thermostat
knob clockwise(towardstheHIGH < > position).