User Manual for UVD Robots
6. Elaborated usage of the UVD Robot
This section lists the individual parts of operating the robot. It is possible to print out specific
pages for daily users to give them easy access of this information
6.1 UVD Robot setup
Setting up the robot implies:
● Creating maps
● Creating disinfection positions
● Adjusting disinfection times
● Setting up network parameters together with IT-dept
● Setting up interfaces for job ordering and adjusting movement sensor on checklist
tablet
All these tasks are to be done by a UVD Robots technician. But maintaining the complete
setup, can be accomplished by receiving proper training from a UVD Robots technician.
Once the robot is set up, it is possible to operate it with ease in order to start disinfecting.
In addition, the manual disinfection mode makes using the robot even easier to use for
disinfecting, since it does not require mapping setup.
11
To Next Page