Copyright ○
C
2021 UVision Innovation Co., Ltd. All rights reserved. 9
Using the UVISION X1
Turning On / Off the Projector
Turning Your Projector On
1. Connect the power cord and appropriate signal cables to the projector.
2. Remove the lens cap.
3. Press the Power button or the Power key by remote control.
4. Turn on your source (computer, DVD player, etc).
5. Connect your source to the projector using the appropriate cable.
6. The input source is determined by the last connected input source. (By default, the input
source of the projector is set to Multimedia). Change the input source of the projector if
necessary.
Note: Turn on the projector before you turn on the source (computer, DVD player, etc.). The
Power button light red until pressed. After turn on the projector, button light blue.
Turning Your Projector Off
1. Press the Power button or the Power key by remote control. Follow the instruction
displayed on screen to properly turn off the projector.
2. Press the Power button or the Power key again.
3. Disconnect the power cord from the electrical outlet and the projector.
Note: The “Power key to standby any key to cancel” message will appear on the screen. The
message disappears after you can press the any key to clear it.
To Next Page
Loading...
General