Uwatec AIR 2 - SCUBAPRO AIR2 Repair Tools and Preparation; Tools Needed for AIR2 Repair; Icon Legend for Repair Guide

SCUBAPRO AIR2 3
rd
& 4
th
Generations
2003 SCUBAPRO
Important note
: The following information is not designed to be a complete training guide for servicing the listed SCUBAPRO regulators. All SCUBAPRO
technicians are required to attend an annual service training program to insure safe handling and servicing of SCUBAPRO products. All SCUBAPRO technicians
must be employed by an authorized SCUBAPRO facility.
2
TOOLS NEEDED FOR REPAIR OF AIR2
P
/
N
4
3
0
4
0
0
0
0
TOOLS
NEEDED
Quantity Part Number Description
1 set 10.102.100
(Peter Built)
Brass o’ring picks
1 tube 41.047.000 Christo-Lube
Christo-Lube
OXYGEN COMPATIBLE LUBRICANT
P/N 41-047-000
1 47.010.000 Counter Mat
1 41.496.101 Lubricant syringe
Monoject
2 Adjustable wrench
1 Small screwdriver
1 20-136-100 Air 2 Spider Tool
(Peter Built)
20-125-200 Seat Slider
(Peter Built)
1 20.500.200
(Peter Built)
Pneumatic Adjusting tool
1 18.300.500 Blow Gun/Air Nozzle
1 ¼” Nut Driver
1 43.040.000 Universal Tool
1 79-400-505 Magnehelic Gauge
(Peter Built)
1 Torque Wrench - 100 in-lb range
ICON LEGEND
Inspect carefully, replace if needed
Monoject
Lubricate properly
Replace annually
Dynamic o’ring, replace annually and lubricate properly
P
/
N
4
3
0
4
0
0
0
0
TOOLS
NEEDED
No tools needed for this step