v.link CI-VL7-MGU - Pre-Installation Steps; Package Contents; Vehicle Integration and Installation; Interface Usage and Control

Version 12.11.2020 HW: 1.3 CI-VL7-MGU
Page2
Contents
1. Prior to installation
1.1. Delivery contents
1.2. Checking the compatibility of vehicle and accessories
1.3. Connectors – video interface
1.4. Settings of the 8 Dip switches
1.4.1. Settings – dips1-3
1.4.2. Settings – dips4-8
1.4.3. Explanation of the individual dipswitch functions
1.4.3.1. Vehicle and monitor selection (Dip1-3)
1.4.3.2. Activating the factory PDC display (Dip 4)
1.4.3.3. Activating the video input (Dip 5+6)
1.4.3.4. Activating the front camera input (dip 7)
1.4.3.5. Rear view camera settings (dip 8)
2. Installation
2.1. Place of installation
2.2. Connection schema
2.3. Connection - picture signal cable
2.4. Connection - Quadlock/CAN
2.5. Connection - video-sources
2.5.1. Audio insertion
2.5.2. After-market front camera
2.5.3. After-market rear-view camera
2.5.3.1. Case 1: Interface receives the reverse gear signal
2.5.3.2. Case 2: Interface does not receive the reverse gear signal
2.5.4. Power supply output
2.6. Adjusting the dynamic guide lines
2.6.1. By i-Drive buttons
2.6.2. By touchscreen (only if supported)
3. Interface operation
4. Specifications