The DMX512 Channel
通道说明
2Channel
NO Function Function Description
1
W dimmer W dimming, linear dimming, from dark to bright
2
Y dimmer Y dimming, linear dimming, from dark to bright
6Channel
NO Function Function Description
1 dimmer Total dimming, linear dimming, from dark to bright
2 strobe Total strobe, from slow to fast
3 function
0-5 empty;
6-100 jump
101-150 gradient
151-200 pulse change
201-255 voice control
4 Function
speed
Function speed, from slow to fast
5 W dimmer W dimming, linear dimming, from dark to bright
6 Y dimmer Y dimming, linear dimming, from dark to bright
After powering on, turn on the power of the console. When the DMX512 console signal
is not received, the display screen flashes; when the DMX512 console signal is received,
the display screen changes from flashing to bright, and the controlled station signal
control.
In the state of address code 001, after multiple machines are connected, if the console is
not connected, the master-slave connection function can be realized, and one of the
devices can be operated. The other devices in the address 001 state follow the host to run
the program synchronously. The DMX512 signal must be cut off.
通电后，接通控台电源，当未接收到 DMX512 控台信号的时候，显示屏闪亮;当接收到
DMX512 控台信号的时候，显示屏由闪亮变常亮，此时受控台信号的控制。
在地址码 001 状态，多机连接后，若没有接控台，可实现主从联机功能，操作其中的一
台设备，其余的在地址 001 状态下的设备跟随主机同步运行程序,主从联机时必须切断
DMX512 信号。
To Next Page
Loading...
