Vacmaster AM1202 - Troubleshooting

12
GB
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The air mover will not
operate.
No power supply.
Check the power supply, cord,
breakers, and fuses.
Faulty power cord.
Unplug and check the power cord.
If damaged, have it repaired by
qualied personnel or contact the
after sales helpline.
Switch in the wrong position.
Move the switch to the "On"
position (I, II, or III).
The switch is faulty.
Have the switch replaced by
qualied personnel or contact the
after sales helpline.
Overload protection has
engaged, shutting off the air
mover.
First check and remove any
power tool or other devices from
the power receptacle. Then set
the switch to the "Off" position (0)
and press the reset button.
The air mover runs but
makes loud scraping
noise.
Damage to the unit has
caused deformed housing or
misaligned centrifugal fan.
Replace the air mover.
The air mover runs but
centrifugal fan does not
rotate.
The centrifugal fan and
housing are jammed.
Replace the air mover.
There is a problem with the
switch or capacitor.
The air mover runs briey
then shuts off due to
overload protection.
The intake grill or air
discharge grill is obstructed.
Remove the obstruction.
The motor is damaged. Replace the air mover.
The air mover runs but
with excessive vibration.
The centrifugal fan has dirt
build up.
Have the air mover inspected by
qualied personnel or contact the
after sales helpline.
The centrifugal fan is
damaged or the motor is bent.
Replace the air mover.
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK, UNPLUG BEFORE
TROUBLESHOOTING.