10
BLOWER OPERATION
This Wet/Dry Vac has blowing capabilities only when the hose is inserted into the blowing port. To
use the blower feature follow the instructions listed.
1. Verify that the power cord is disconnected from the outlet (g.1).
2. Make sure the collection tank is empty before using as a blower.
3. Remove hose from the vacuum port.
4. Insert the larger end of the hose into the blowing port on the backside of the power head and
push in tightly (g. 2).
5. Fit the desired attachment to the hose (g. 3).
6. Ensure the power switch is turned to the ‘O” OFF position and plug into the power supply (g. 4).
7. Before turning on the vac, rmly hold loose end of the hose. Turn the motor on by ipping the
switch to the ‘I’ ON position (g. 5).
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1
(OR IN CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT
BE INHALED.
CAUTION:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
4. Verify that the switch is in the ‘O’ OFF position before plugging the power cord into the outlet
(g. 6)
5. Turn the motor on by ipping the switch to the ‘I’ ON position (g.7).
6. After use, empty the collection tank, clean and dry the inside and outside before storage.
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely
in the liquid; leave a gap at the tip of the nozzle opening to allow air inow. The machine is tted
with a oat valve that stops the suction action when the collection tank reaches its maximum
capacity. You will notice an increase in motor speed. When this happens, turn off the machine,
disconnect from power supply, and drain the liquid into a suitable receptacle or drain. After wet
vacuuming, turn the machine off and remove plug from power supply. Empty the collection tank,
clean and dry the inside and outside before storage.
REMEMBER! The foam wet lter must be removed after wet vacuuming and the cartridge lter
must be installed before dry vacuuming again.
To Next Page
Loading...
