14
CARPET/UPHOLSTERY CLEANING
OPERATION
WARNING: DO NOT RUN THE VACUUM IN DETERGENT MODE WITHOUT SOLUTION
IN THE CLEANING SOLUTION TANK.
WARNING: USE ONLY MANUFACTURER RECOMMENDED CLEANING SOLUTION
WITH THIS VACUUM CLEANER.
WARNING: DO NOT REPLACE FURNITURE UNTIL THE CARPET IS COMPLETELY
DRY!
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. To prepare your vacuum cleaner for carpet/upholstery cleaning, remove the cartridge lter.
3. Carefully install the supplied foam wet lter over the lter cage, making sure the lter cage is
completely covered (Fig. 2).
4. Remove the cleaning solution tank from the vacuum base and pour the cleaning solution
mixture into the tank. To make the cleaning solution mixture, mix 3 oz. of cleaning solution per 1
gallon of water (Fig. 3).
NOTE: A 17 oz. (500ml) bottle of cleaning solution is provided with this vacuum cleaner. Ensure
the cleaning solution and water are mixed at the correct ratio.
3
4
1
2
5
6
7 8 9 10
11 12
NOTE: ALWAYS DRY VACUUM THE AREA BEING CLEANED BEFORE USING THE
SHAMPOO MODE.
CAUTION: BEFORE YOU USE THIS PRODUCT TO SHAMPOO CLEAN AN AREA,
TEST YOUR WET/DRY SHAMPOO VACUUM AND THE CLEANING SOLUTION ON A SMALL
HIDDEN AREA FOR COLORFASTNESS. IF THE COLOR IS AFFECTED, DO NOT USE.
To Next Page
Loading...
