Need help?Do you have a question about the Vacon NXS series and is the answer not in the manual?
General| Output Voltage Range | 0 V to Input Voltage |
|---|---|
| Frequency Range | 0 Hz to 500 Hz |
| Control Method | Scalar control |
| Fieldbus Communication | Modbus RTU |
| Communication Options | CANOpen |
| Ambient Temperature Range | -10 to 50 °C (derating may apply above 40 °C) |
| Storage Temperature Range | -40 to 70 °C |
| EMC Filter | Built-in (Class A) |
| Relative Humidity | 5% to 95% (non-condensing) |
Details physical board slots for NXS/NXP drives.
Details physical board slots for NXL drives.
Categorizes VACON option boards into types A, B, C, and D.
Specifies electrical and environmental data for option boards.
Describes electrical isolation of connections and grounds.
Details specifications for analogue input types (mA/V).
Details specifications for analogue output types (mA/V).
Explains use and limits of +24V control voltage output.
Illustrates digital input signal logic and wiring setups.
Covers board mounting safeguards and terminal coding.
Explains terminal block coding for correct connections.
Guides on correct board placement in slots.
Explains unique identification codes for option boards.
How to map I/O to functions using address codes.
Using NCDrive tool for terminal-to-function mapping.
Setting parameters for board functions via keypad.
Requirements for control cable types and tightening torques.
Proper grounding procedure for control cables.
How to use and fill out the board information sticker.
Details of basic I/O boards, used for basic I/O functions.
Description of OPTA1 standard I/O board with its terminals.
Description of OPTA2 relay board with two relay outputs.
Description of OPTA3 relay board with thermistor input.
Description of OPTA4 encoder board for TTL type encoders.
Description of OPTA5 encoder board for HTL type encoders.
Description of OPTA7 duplicate encoder board for HTL encoders.
Description of OPTA8 basic I/O board with isolated analogue I/O.
Description of OPTA9 basic I/O board with larger terminals.
Description of OPTAL dual I/O expander board.
Description of OPTAE encoder board with direction signals.
Description of OPTAN standard I/O board with isolated digital inputs.
Details of I/O expander boards for increasing drive I/O.
Description of OPTB1 with six bidirectional terminals.
Description of OPTB2 with thermistor input and relay outputs.
Description of OPTB4 with analogue input/outputs.
Description of OPTB5 with three relay outputs.
Description of OPTB8 temperature board with Pt-100 inputs.
Description of OPTB9 digital inputs and relay output.
Description of OPTBB absolute encoder board with Endat interface.
Description of OPTBH temperature measurement board.
Adapter boards for connecting AC drive to communication buses.
System Bus adapter board with optical I/O.
System Bus/Monitor Bus adapter board with optical/CAN.
RS-232 adapter board for application engineering.
Monitor Bus adapter board for NCDrive PC tool.
To Next Page
