EasyManua.ls Logo

Vacon NXV0010 - SAFETY; Manual Warning Symbols; Product Warning Marks; General Safety Rules

Vacon NXV0010
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
vacon • 3
24-hour support: +358 (0)201 212 575 • Email: vacon@vacon.com
1. SAFETY
1.1 Danger and warning symbols used in this manual
This manual contains clearly marked cautions and warnings which are intended for your personal
safety and to avoid any unintentional damage to the product or connected appliances.
Please read the information included in cautions and warnings carefully.
The cautions and warnings are marked as follows:
=
Dangerous voltage! Risk of electric shock
=
General warning! Risk of equipment damage
1.2 Symbols and warning marks used in the product
The product carries some additional symbols and marks. The meanings of these are as follows:
=
Dangerous voltage! Risk of electric shock
i
= See User’s Manual
5
min
= Caution! Risk of electric shock! Energy storage timed discharge:
5 minutes
1.3 Safety rules
ONLY A COMPETENT ELECTRICIAN IS ALLOWED TO CARRY OUT THE ELECTRICAL IN-
STALLATION! RISK OF ELECTRIC SHOCK!
The solar inverter VACON 8000 SOLAR has been designed to be installed in enclosed places. It shall
be protected against harsh weather conditions.
The solar inverter VACON 8000 SOLAR can only be opened by qualified technicians. Inside the inver-
ter module, there is no element which can be fixed or adjusted by the user.
There is a serious risk of electric shock, even after the device has been disconnected
from the mains supply or
solar panels. This electric shock may cause death or serious
injury.
If the short circuit current of the grid is higher than the short circuit withstanding ca-
pability of the QA2, additional circuit breaker must be installed. If the possible short
circuit current at the grid point of connection is higher than the solar inverter’s break-
ing capacity, additional current limiting device must be installed (see chapter 5.4).
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.

Related product manuals