Vacon NXV0040 - User Manual

Questions and Answers

J
jamesernestSep 12, 2025
What to do if Vacon Inverter shows Division by zero in application?
- P
  Patrick DodsonSep 12, 2025
  If a division by zero has occurred in the application program of your Vacon Inverter, contact your distributor if the fault re-occurs while the converter is in run state.
A
Amanda ConnerAug 25, 2025
How to troubleshoot overcurrent or overvoltage on a Vacon Inverter?
- L
  Laurie MccormickAug 25, 2025
  If your Vacon Inverter is showing an overcurrent or overvoltage error, it means the AFE has detected too high a current in the cables or the DC-link voltage has exceeded the drive limit, possibly due to high overvoltage spikes in the supply. Check the input voltage.
J
Jeremy BaileyAug 25, 2025
Why does my Vacon Inverter show an input phase supervision fault?
- J
  Jason JonesAug 26, 2025
  An input phase supervision fault on your Vacon Inverter indicates a missing input line phase. Check the supply voltage, fuses, and cable.
G
Gilbert JacksonSep 23, 2025
What to do if Vacon Inverter shows Input Switch in wrong state?
- S
  sandovalthomasSep 23, 2025
  If your Vacon Inverter indicates that the Input Switch is in the wrong state, check the input Switch.
B
burkejoshuaSep 12, 2025
What causes External Trip on Vacon Inverter?
- M
  Michael HatfieldSep 12, 2025
  An External Trip on a Vacon Inverter is caused by a trip signal from a digital input. Remove the fault situation from the external device.
M
Michael GeorgeSep 16, 2025
What to do if Vacon Inverter shows AC voltage on line side is above the max limit?
- K
  Kaitlin LoweSep 16, 2025
  If your Vacon Inverter indicates that the AC voltage on the line side is above the maximum limit, check the AC Voltage.
M
mariafisherSep 5, 2025
What does an EEPROM checksum fault mean on a Vacon Inverter?
- S
  Sarah DaySep 5, 2025
  An EEPROM checksum fault on a Vacon Inverter indicates a parameter save fault, faulty operation, or component failure. Should the fault re-occur, contact your local distributor.
B
Blake SmithSep 6, 2025
What to do if my Vacon Inverter displays a microprocessor watchdog fault?
- W
  whickmanSep 6, 2025
  If your Vacon Inverter displays a microprocessor watchdog fault, it could be due to faulty operation or component failure. Reset the fault and restart. Should the fault re-occur, contact your local distributor.
J
Jeremy RobertsonSep 18, 2025
What to do if Vacon Inverter shows AC voltage on line side is below the min limit?
- H
  harriskaitlynSep 18, 2025
  If your Vacon Inverter indicates that the AC voltage on the line side is below the minimum limit, check the AC Voltage.
C
Caroline LeeAug 30, 2025
How to resolve 'Start-up prevented' error on Vacon Inverter?
- S
  Sabrina BellAug 30, 2025
  If the Vacon Inverter displays 'Start-up prevented', it means the start-up of the drive has been prevented because the run request is ON when a new application is loaded to the drive. Cancel prevention of start-up if this can be done safely, or remove the run request.