EasyManua.ls Logo

Vacon NXV0040 - 3 Receipt of Delivery; Type Designation Code; Lifting the Unit out of the Transport Packaging

Vacon NXV0040
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RECEIPT OF DELIVERY vacon • 7
24-hour support: +358 (0)201 212 575 • Email: vacon@vacon.com
3. RECEIPT OF DELIVERY
3.1 Type designation code
Vacon 8000 Solar inverters have undergone scrupulous tests and quality checks at the factory before
they are delivered to the customer. However, after unpacking the product, check that no signs of
transport damages are to be found on the product and that the delivery is complete (compare the
type designation of the product to the code below).
VACON NXV 0010 4 A 2 L A1A2 D700XX
nk3_1b_solar.ai
Vacon NXV = Solar power inverter
Nominal power
0010 = 10 kW, 0100 = 100 kW etc.
4 = Galvanic isolation transformer, ouptut 3 x 400 VAC
Control keypad and display on the cabinet door:
A = standard (alpha-numeric)
B = no local control keypad
F = dummy keypad
G = graphic display
Enclosure class:
2 = IP21/NEMA 1
EMC emission level:
L = fulfils requirements of category C3 of standard EN61800-3 (2004),
2nd environment and rated voltage less than 1000V
T = fulfils standard EN61800-3 (2004) when used in IT networks
Option boards; each slot is represented by two characters where:
A = basic I/O board, B = expander I/O board,
C = fieldbus board, D = special board, 00 = Not used
Figure 3-1. Type designation code
3.2 Lifting the unit out of the transport packaging
Before unpacking the device, check the correctness of delivery by comparing your order data to the
drive information found on the package label.
The unit is delivered either in a wooden box or a wooden cage. The box may be transported either
horizontally or vertically, while transportation of the cage in a horizontal position is not allowed. Al-
ways refer to shipping marks for more detailed information. To lift the unit out of the box, use lifting
equipment capable of handling the weight of the cabinet.
There are lifting lugs on the top of the cabinet and these lugs can be used to lift the cabinet into an
upright position and to move it to the place needed.
Units NXV 0010 and NXV0100 may be lifted as shown in Figure 3-2, in vertical or horizontal position.

Related product manuals