vacuubrand CVC 2 - Safety Icons and Notes; Important Notes; Prohibited Action Warning; Hot Surface Caution

page 3 of 36
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check
carefully the validity of this document with respect to his product. manual-no.: 99 90 20 / 01/12/2004
Attention! Important notes!
Not permitted! Misuse may cause damage.
Caution! Hot surface!
Isolate equipment from mains.
Note.
Contents
Safety information! ....................................................................................................4
Technical data............................................................................................................6
Description ................................................................................................................7
General view basic setups ........................................................................................9
How to work with the controller ..............................................................................10
General view basic setup ”Standard” ....................................................................11
Basic setup Standard .............................................................................................12
Vacuum management with VMS Module A ............................................................16
Basic setup Management or Management Plus ...................................................20
General view basic setup VACUU•LAN .................................................................22
Basic setup VACUU•LAN ........................................................................................23
How to determine the best distillation conditions ................................................ 26
Installation and accessories ...................................................................................27
Troubleshooting ......................................................................................................29
Readjustment .......................................................................................................... 31
Calibration in the factory.........................................................................................32
Notes on return to the factory ................................................................................33
Health and safety clearance form ..........................................................................34