How to fix VADDIO IP Camera when light is off but web interface and video are available?
If the light on the front of your VADDIO IP Camera is off, but the web interface and video are still available, it's likely that the status light is turned off. You can turn it back on using the LED On setting on the System page (General tab), or using the Telnet command camera led on.
What to do if VADDIO IP Camera has no video and the light on the front is off?
If your VADDIO IP Camera isn't showing any video and the front light is off, here are a few things to check: * The network cable to the camera might be bad. Try using a known good cable from the PoE power injector to the camera. * The wall outlet might not be active. Check if the outlet powers another device, like a laptop or phone charger. * If the above steps don't work, the camera or its PoE power injector might be faulty.
General| Resolution | 1080p |
|---|---|
| Frame Rate | Up to 60 fps |
| Pan/Tilt | Pan: ±170°, Tilt: +90°/-30° |
| Focus | Auto/Manual |
| White Balance | Auto/Manual |
| Exposure Control | Auto/Manual |
| IP Streaming | RTSP, RTMP |
| Video Output | HDMI, USB |
| Camera Type | PTZ |
| Audio | Built-in Microphone |
| Connectivity | Ethernet, USB |
| Power | PoE |
| Mounting | Wall |
| Dimensions | 144mm H x 146mm W x 146mm D |
To Next Page
