1 Safety
6 Operating instructions aroSTOR 0020285064_00
▶ Do not inhale any steam or
gases that escape from the
refrigerant circuit as a result
of leaks.
▶ Avoid skin or eye contact with
the refrigerant.
▶ In the event of skin or eye
contact with the refrigerant,
seek medical advice.
1.8 Risk of injury and
material damage due to
maintenance and repairs
carried out incorrectly or
not carried out at all
▶ Never attempt to carry out
maintenance work or repairs
on your product yourself.
▶ Faults and damage should
be immediately rectified by a
competent person.
▶ Adhere to the maintenance
intervals specified.
1.9 Risk of damage from
corrosion caused by
unsuitable room air
Sprays, solvents, chlorinated
cleaning agents, paint, adhes-
ives, ammonia compounds,
dust or similar substances
may lead to corrosion on the
product.
▶ Ensure that the air supply is
always free of fluorine, chlor-
ine, sulphur, dust, etc.
▶ Ensure that no chemical sub-
stances are stored at the in-
stallation site.
1.10 Dangers of modifying
product surroundings
Some types of installation and
conversion work in your home
can impair the way your product
operates.
▶ Consult your installer before
undertaking the work in ques-
tion.
1.11 Frost damage due to
insufficient room
temperature
If the room temperature is set
too low in individual rooms, it
cannot be ruled out that sec-
tions of the heating installation
might be damaged by frost.
The product may release cold
air into the room. This means
the room temperature can fall
below 0 °C.
▶ If you are going to be away
while the outside temperature
is low, ensure that the heating
installation remains in oper-
ation and that the rooms are
sufficiently heated.
▶ You must observe the frost
protection instructions.
To Next Page
Loading...
Need help?
General
