Need help?Do you have a question about the Vaillant time SWITCH 110 and is the answer not in the manual?
This time clock is not suitable for use with an external frost thermostat.
Slide tappets in for heating ON, slide out for heating OFF.
Time of day is indicated by the reference triangle (4) on a 24-hour clock.
Describes constant heating off and automatic operation based on tappet settings.
Turn the minute hand clockwise to align with the correct time of day using the reference triangle.
Set tappets (4) and (5) via the inspection window according to heating requirements.
Timer retains program on mains failure; time must be reset.
Release blanking plate, secure control box, and insert programmer into position.
Confirms CE Mark compliance and outlines liability for instruction non-observance.
This time clock is not suitable for use with an external frost thermostat.
Slide tappets in for heating ON, slide out for heating OFF.
Time of day is indicated by the reference triangle (4) on a 24-hour clock.
Describes constant heating off and automatic operation based on tappet settings.
Turn the minute hand clockwise to align with the correct time of day using the reference triangle.
Set tappets (4) and (5) via the inspection window according to heating requirements.
Timer retains program on mains failure; time must be reset.
Release blanking plate, secure control box, and insert programmer into position.
Confirms CE Mark compliance and outlines liability for instruction non-observance.
General| Category | Switch |
|---|---|
| Model | time SWITCH 110 |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Power consumption | 1 VA |
| Protection class | IP20 |
| Switching capacity | 16 A resistive load |
| Number of programs | 1 |
| Operating temperature | 0 - 50 °C |
| Storage temperature | -20 °C to +60 °C |
To Next Page
