Chapter 3 _______________________________________________________________ Installation
VAISALA ________________________________________________________________________ 9
CHAPTER 3
INSTALLATION
This chapter provides you with information that is intended to help you
install this product.
Installation to Pole
The TERMBOX is connected to the pole with the use of the
TERMBOXFIXSET mounting set.
1. Connect the back plate to the TERMBOX using the four mounting
screws. Tighten all four screws to ensure the plate is firmly in
place.
2. With ∅104 mm, ∅132 mm, or ∅168 mm poles, select two
appropriate-sized angle clips from the TERMBOXFIXSET
mounting set and fasten the TERMBOX with the two angle clips
and four M8 nuts and washers to the pole. See Figure 2 on page 10
for details.
3. In case of a ∅75 mm pole, select the two angle clips shown in Figure
3 on page 11. Fasten the TERMBOX with the two angle clips and four
M6 screws, nuts, and washers to the pole. For details, refer to Figure 3 on
page 11.
To Next Page
Loading...