Chapter 3 _______________________________________________________________ Installation
VAISALA _______________________________________________________________________ 11
0210-016
Figure 3 Installation to ∅75 mm Pole
The following numbers refer to: Figure 3 above
1 = Back plate
2 = TERMBOX
3 = Mounting screws
4 = Angle clips
5 =
∅75 pole (for example, FD12(P) or Wind Mast)
6 = M6 screws, nuts, and washers
Equipment Grounding
It is essential to appropriately ground the TERMBOX. This will ensure
proper operation of the unit. Ground the TERMBOX by using a jacketed
grounding cable and a conductive grounding rod, as shown in Figure 4 on
page 12.
To Next Page
Loading...