32 33EN EN
Using the appliance Using the appliance
B B
Filling the rinse aid reservoir
1. Open the lid of the rinse aid reservoir by lifting up the handle.
2. Pour the rinse aid slowly into the dispenser, avoid overfilling. Any spilled rinse aid should
be removed with a cloth.
3. Properly close the lid after filling the reservoir.
Adjusting the rinse aid setting
To achieve a better drying performance with limited rinse aid, the dishwasher is designed to
adjust the consumption by user. Follow the below steps.
1. Open the door, switch on the appliance.
2. Within 60 seconds after step 1, press the Program button “>”more than 5 seconds, and
then press the “+” button to enter the set model, the rinse aid indication blinks as 1Hz
frequency.
3. Press the Program button “>” to select the proper set according to your using habits,
the sets will change in the following sequence: D3->D4->D5->D1->D2 ->D3. The higher the
number, the more rinse aid the dishwasher uses.
4. Without operation in 5 seconds or press the Power button to complete the setup and exit
the setup mode.
To Next Page
Loading...
Need help?
General
