34 35EN EN
Using the appliance Using the appliance
B B
Program Table
• The table shows various information about the programs.
• Consumption values and program duration are only indicative except for ECO program.
( ) indicates that the program uses rinse aid in the last rinse.
Program Description of cycle
Detergent
pre/main
wash
Running
time(min)
Energy
(kWh)
Water
(L)
Rinse
aid
Auto
Pre-wash (45 °C)
Wash (55-65 °C)
Rinse
Rinse
Rinse (50-60 °C)
Drying
5/19g 105-179 0.930-1.470 10.3-17.0
Hygiene
Pre-wash (45 °C)
Wash (72 °C)
Rinse
Rinse (50 °C)
Rinse (60~65 °C)
Drying
5/19g 165 1.650~1.720 16.0
Universal
Pre-wash (45 °C)
Wash (55 °C)
Rinse
Rinse (60~65 °C)
Drying
5/19g 130 1.175~1.250 13.5
(*EN60436)
Wash (45 °C)
Rinse
Rinse (43 °C)
Drying
24g 280 0.559 9.0
Glass
Pre-wash (40 °C)
Wash (50 °C)
Rinse
Rinse
Rinse (55~60 °C)
Drying
5/19g 99 0.825~0.900 11.5
58 min
Wash (50 °C)
Rinse
Rinse (55 °C)
Drying
20g 58 0.740~0.795 11.5
Rapid
Wash (45°C)
Rinse
Rinse (50°C)
15g 45 0.650~0.710 9.0
Program selection
Program Description of cycle
Detergent
pre/main
wash
Running
time(min)
Energy
(kWh)
Water
(L)
Rinse
aid
Self-
cleaning
Wash (70 °C)
Rinse
Rinse (65~72 °C)
Drying
20g 130 1.245~1.320 12.0
NOTE
The ECO program is suitable to clean normally soiled
tableware, that for this use, it is the most efficient program
in terms of its combined energy and water consumption,
and it is used to assess compliance with the EU ecodesign
legislation.
Saving energy
1. Pre-rinsing of tableware items leads to increased water and energy consumption and is
not recommended.
2. Washing tableware in a household dishwasher usually consumes less energy and water
in the use phase than hand dishwashing when the household dishwasher is used according
to the instructions.
Starting a program
1. Pull out the lower and upper basket, load the dishes and push them back.
2. Add the detergent in the dispenser.
3. Insert the plug into the socket. For the power supply specification please refer to last page
”Product information sheet”. Make sure that the water supply is turned on within specified
range of pressure.
4. Open the door, Press the Power button.
5. Choose a program then close the door, the dishwasher will start the program.
To Next Page
Loading...
Need help?
General
