MUS0330202 03/10/2014
VALCO MELTON S.L.U. Pol. Ind. Agustinos C/G 34 3116 0 ORCOYEN, NAVARRA
TEL: +34 948 321580 Fax: +34 948 326584 melton@melton.es www.valcomelton.com
8.3. REPAIRING THE MANIFOLD:
The manifold is the element that distributes Hot-Melt, after it has been
filtered, to the hoses and guns.
It is assembled at the bottom of the tank so that the tank heaters heat it
indirectly.
The manifold has six outlet ports to connect the Hot-Melt hoses; three
at the bottom and another three at the front.
Do not disassemble the manifold. This operation should only be
done if there is a Hot-Melt leak between the tank and the manifold.
To Next Page
Loading...
Need help?
General
