4 Charging your system
4.1 Timing units
To charge your timing units, connect the units to the provided 12V daisy chain charger.
The charging LED, located on the back of each Smartspeed Pro unit, will flash red when charging.
The LED will turn solid red when fully charged.
Note:
• It is recommended that you charge your timing units regularly.
• If the units are used whilst connected to the charger, the units will automatically turn off
after a short period. This is to protect the batteries.
4.2 SmartHub
To charge your SmartHub, connect the SmartHub to the provided 5V charger.
The power LED light, located on the bottom left of the SmartHub, will flash when on.
The charging LED light, located on the bottom right of the SmartHub, will flash when charging.
5 Software setup
5.1 SmartSpeed App
The SmartSpeed app is the data capture application for the SmartSpeed system.
The app is available for iOS and Android devices and can be downloaded from the App Store and
Google Play Store – search for SmartSpeed.
Once the SmartSpeed app has been downloaded onto a device, an account is required to log in to
the app.
To create a SmartSpeed account:
1. Open the SmartSpeed app on the device
2. Select Register
3. Complete the registration form
4. Select Create my account
5. Log in
To Next Page
Loading...