8 Run a session
To get started with running a session, ensure:
1. You are logged into the SmartSpeed app
2. The SmartHub is connected via Bluetooth
3. Your timing units are turned on
To run a session with the SmartSpeed app:
1. Select Start Session
2. Ensure your timing units are automatically scanned in
Note: Timing units need to be on the same channel as SmartHub to be automatically scanned in. If
you need to change channel, go to SmartHub Tools > System Setup in the SmartSpeed app.
3. Select a Team
4. Select number of Tracks
5. Select a Drill
6. Select Ready
7. Physically walk through the timing gates in the order they have been set up
8. Confirm the order of the timing gates displayed on screen
Note: The battery status of each timing unit will be displayed on screen
9. Select Start
10. Select User Options as required for the protocol
11. Select the Tick Icon
12. Run through the protocol as configured
Note: Results will automatically display onscreen, and the name of the current participant will
display on the right, above the timing clock
13. Select Stop to end the session
14. Select Confirm (or cancel to continue session)
15. Select View Session Results or New Session Setup
9 Care
The following is recommended to ensure the protection of your SmartSpeed Pro system:
• When not in use, store your SmartSpeed Pro system in the provided hard travel case.
• In the case of wet weather, ensure the SmartSpeed system components are dry prior to
storage.
• Ensure the timing units and SmartHub are turned off after each session
• Your SmartSpeed Pro system should only be charged using the chargers provided
• Once charged, disconnect the SmartHub and ensure it is turned off.
To Next Page
Loading...