Vallox 3722 - Page 16

16
SETUP WIZARD
EXPERT SETTINGS
BOOST PROFILE
To make the Boost profile settings, proceed as follows:
1. The setup wizard for Boost profile opens.
NOTE
Once you have set the fan speed for the At home profile, the fan
speed for the Boost profile will by default be set to +30% of the At
home profile fan speed. It is recommended that this fan speed
setting be used for the Boost profile. However, the setting can be
changed as required.
2. Use the Plus and Minus buttons to set the Boost profile fan
speed as a percentage of the maximum output ratio.
3. Press the Right arrow button.
4. The temperature setup opens.
5. Set the desired supply air temperature for the Boost profile
by using the Plus and Minus buttons. You can adjust the
temperature in the range +10°C ... +25°C.
6. Press the Right arrow button.
7. The setup for automatic fan speed control based on the
relative humidity opens.
8. Use the Plus and Minus buttons to select whether the
automatic fan speed control, based on the relative humidity
of air, is used or not.
9. Press the Right arrow button.
10. The setup for automatic fan speed control based on the
carbon dioxide level opens.
11. Use the Plus and Minus buttons to select whether the
automatic fan speed control, based on the carbon dioxide
level, is used or not.
12. Press the Right arrow button.
13. A display for setting the profile timer opens.
14. Use the Plus and Minus buttons to select whether the profile
timer function is used or not. The options are:
ĆOn — When the timer is on, the Boost profile is used only
for the period specified in the timer.
ĆOff — When the timer is off, the Boost profile is used until
you (or the Week clock) change the profile.
15. Press the Right arrow button.
16. A display for setting the profile timer duration opens.
17. Set the profile timer duration in minutes by using the Plus and
Minus buttons.
18. Press the OK button.