4FXM70EN - 8/2022
38
Continue to follow rotation of rotor while directing tube into
pump head. At this point, you may need to pull the tube to
stretch tubing into position.
Continue to pull the tube to allow enough room to slide
discharge tting into pump head tongue and groove. Once
discharge tting is secured in pump head, stop pump by
pressing STOP button. Replace pump head cover. Pump will
ask you if you’d like to reset tube timer. If you choose yes,
current tube time will display for 5 seconds before resetting to
zero. Make note of your displayed tube life. Select Yes again to
reset tube life timer.
Locate your new tubing. Please see below on how to install
new Tube Assembly into Pump Head.
Insert suction tting into pump head. Remove your ngers
from pump head. Start pump by pressing START button.
Grab hold of Tube and guide tubing into pump head.
Introduce tubing into pump head while the rotor is rotating,
use guide rollers . Avoid using ngers to guide the tubing.
Stop pump at anytime by pressing STOP button. Start pump
by pressing START button.
To Next Page