Page 20
© Baxi Heating U.K. Limited 2011.
What does the button do?
Press the button once.
This turns the effect on. The indicator lamp will flash green for
approximately five seconds, after this time the lamp will no longer be visible.
Press the button a second time.
This will turn the 675 watt heater on. The effect will already be on.
The indicator lamp will flash amber for approximately five seconds, after this time the
lamp will no longer be visible.
Press the button a third time.
This will turn the 1350 watt heater on. The effect will already be on.
The indicator lamp will flash red for approximately five seconds, after this time the
lamp will no longer be visible.
Press the button a fourth time.
Pressing this button at any time whilst the effect or heater are in
operation will turn the effect and heater off.
12. CLEANING AND MAINTAINING THE
HEATER
Important Safety.
Before undertaking maintenance always disconnect the heater from the electricity
supply by removing the 3 pin plug and allow the heater to cool completely.
How do I Clean my heater?
The heater and plastic parts need only to be wiped clean with a dry soft cloth; do not
use polishes or abrasive materials. This is especially important when cleaning the
effects screen.
Cleaning the Filter Panel.
The filter panel requires regular cleaning. We recommend cleaning the filter at
least once a month. The filter may require cleaning more frequently depending
upon use. To gain access to the filter remove the ash pan and firefront. It is not
necessary to remove the filter for cleaning. Clean the filter using a vacuum
fitted with a soft brush attachment. Do not apply pressure to the filter as this
may cause damage.
INSTALLER AND OWNER GUIDE
To Next Page
