VALPAR VCWS14 - Trouble Shooting Table

4
PART 2 VCWS14 TROUBLE SHOOTING TABLE 1/25/00
PROBLEM POSSIBLE CAUSE SOLUTION
2A
VCWS14 WILL 1) BLOWN FUSE REPLACE FUSE
NOT BEEP
2) DEFECTIVE CONTROL BOX CALL VALPAR
CUSTOMER SERVICE
3) BREAK IN WIRES REWIRE VCWS14 REFER
REFER TO FIGURE 14.2
4) MICROSWITCH IS REPOSITION WHEEL
POSITIONED ON THE STOP REFER TO PART 1C
2B
VCWS14 BEEPS BUT 1) BLOWN FUSE REPLACE FUSE
DOES NOT RUN
2) DEFECTIVE CONTROL BOX CALL VALPAR
CUSTOMER SERVICE
3) BREAK IN WIRES REWIRE VCWS14 REFER
REFER TO FIGURE 14.2
4) DEFECTIVE MOTOR REPLACE MOTOR
REFER TO PART 3C
5) MICROSWITCH IS REPOSITION WHEEL
POSITIONED ON THE STOP REFER TO PART 1C
2C
VCWS14 RUNS BUT THE 1) SPEED INCORECTLY CHECK WHEEL SPEED
SPEED WILL NOT ADJUSTED ADJUSTMENT REFER TO
ADJUST PART 1A
2) DEFECTIVE CONTROL BOX CALL VALPAR
CUSTOMER SERVICE
3) DEFECTIVE MOTOR REPLACE MOTOR
REFER TO PART 3C
2D
VCWS14 RUNS BUT THE 1) LOOSE PEDESTAL TIGHTEN SET SCREWS
WHEEL DOES NOT TURN SET SCREWS REFER TO PART 3D
2E
VCWS14 RUNS BUT IT 1) DEFECTIVE CONTROL BOX CALL VALPAR
SKIPS STOPS OR DOES CUSTOMER SERVICE
NOT STOP IN THE
RIGHT PLACE 2) BROKEN MICROSWITCH REPLACE
MICROSWITCH