Valtra 95 - Page 28

24
Model Code Page
21. Engine
1. 11. 2000
95--115
X100--X120
210 2
D . Connecting rods, weight classes 4.................................................
E. Changing piston rings 5..........................................................
F. Check i n g p i s t on 6...............................................................
G. Fitting piston pin 6..............................................................
H. Fitting piston together with connecting rod 6........................................
3. Balancer unit, 420---engines:
A. Removing and dismantling balancer unit 7..........................................
B. Reconditioning balancer unit 7....................................................
C. Fitting balancer unit 8............................................................
Engine timing gears (Op. no. 214)
A. Removing timing gear casing 1...................................................
B. Reconditioning idler gear 1.......................................................
C. Fitting timing gear casing 2.......................................................
Lubrication system and oil sump ( Op. no. 215):
A. Reconditioning oil relief valve for lubrication oil pressure 1.............................
B. Removing and dismantling lubricating oil pump 1....................................
C. Assembling and fitting lubricating oil pump 2.......................................
D . Fitting oil sump gasket 2.........................................................
E. Lubricating oil quality requirements 3..............................................
Inlet a nd exhaust sy stem, turbocharger ( Op. no. 216):
A. Checking air filter 1..............................................................
B. Checking inlet and exhaust system 1...............................................
C. Checking turbocharger 1.........................................................
D. Reconditioning turbochar ger 3....................................................
E. Fitting turbocharger 5............................................................
Working orders (Op. no. 219) 1................................................